Focus RS MK2 650cc Bosch Injector set - NEW Multi hole

 

Direct Fittment in Place of the original Ford Focus RS and ST Injectors

Original Ford / Volvo spray pattern charteristics

Excellent response characteristics from the multi hole design

High Impedance compatability with all stock Ford/Volvo/Bosch ECU

Better fuel economy than the single-hole disc 'custom machined' types.

As used in our 400-425 conversions

A  new evolution in larger injectors for the Focus RS mk2.
Bosch direct replacement injectors for all the Ford Focus RS and ST power seekers looking for 400-430bhp with the same spray pattern characteristics as OE 500cc units !!!!!

These Higher Flow 650cc Bosch Injectors utilize a multi-orifice tip for improved mixture preparation and atomization. This results in lower Fuel Consumption per BHP and better idle quality than many single-hole disc 'custom machined' pencil stream injectors with less flow.

Our own demo 400bhp Focus RS had been using the old pencil stream single hole custom machined type of injector for some time.A simple swap over to these was all that was needed to help power fuel consumption and low speed drive-ability.

The risks of bore wash and poor atomisation have not yet been realised at this early stage in the Focus RS mk2 life cycle.We believe these new injectors will help guard against expensive engine rebuilds later in the cars life by utilizing a much better and original equipment spray pattern,just the way that Ford and Volvo intended.


Specifications: Coil Resistance: 12 Ohms  
Spray Pattern: Wide Split Cone, (6 orifice)
Electrical Connector: USCAR (New-style V=EV6 / Oval / LS2)
Static Flow Rate @ 43.5PSI (300kPa)